-
Directions to site
-
Well Drillers Report so
Atlantic Water Investigations Limited can send it along
with the thermal conductivity data at end of test to Ewbanks &
Associates
-
Have site level and smooth to back up
van with trailer close to well, if site is not accessible for
van client needs to have someone with a vehicle to back trailer
up to well head, daily rate applies for all standby time
-
Have driller place generator no further
than 20 feet from well but not in way of trailer to set up and
leave site
-
Have well casing cut flush to ground
easier to insulate, otherwise assume heat going back into
formation
-
Leave loop pipes each sticking up 4 feet
above ground, less than 4 feet makes it difficult to connect
plumbing unit to loop
-
Composition of Liquid in loop
-
Make sure loop filled with water/liquid
to top of well casing into loop extending above ground
-
Provide power and maintain refueling of
generator for test; contractor generator recommended; continuous
power needed for entire duration of test, if for any reason
there is power interruption (lack of fuel for generator,
generator trips out test will need to start allover from
beginning, daily rate applies for all standby time)
-
MAKE SURE GENERATOR SET TO 3
PHASE 240 VOLT, OTHERWISE GENERATOR HAS BEEN SET TO
209 VOLTS AT RENTAL OUTLET AND 4500 WATT HEATER WATT
ELEMENTS RUN AT 3300 WATTS.
-
Provide a contractor generator For
example with a 300 loop system required watts:
Minimum
standard watts: 15 watts/ft * 300 ft = 4500 watts
Maximum
standard watts: 25 watts/ft * 300ft = 7500 watts
-
For example with a 500 loop system
required watts:
Minimum standard watts: 15 watts/ft *
500 ft = 7500 watts
Maximum standard watts: 25 watts/ft *
500ft = 12500 watts
-
Safety equipment required? Site Orientation
Safety Meeting?
-
As much detail on the list below as possible:
- CLIENT:
- LOCATION: (enter as much data as possible, street address of well)
- DATE TEST PERFORMED:
- BOREHOLE DEPTH:
- BOREHOLE DIAMETER:
- LOOP
DESCRIPTION: (ie. HPDE SDRH 1.25 inch Thermal Polytube)
- TYPE OF GROUT: (ie.
WYOBEND HI SOLIDS THERMAL ENHANCED GROUT
Therm-Ex Grout 50 lbs Grout 250 lbs
silica sand #00 32 gallons water)
- CEMENT SEAL DESCRIPTION:
- STATIC WATER
LEVEL:
